4.9 (546) · $ 13.50 · In stock
Hello. I have bought a hall sensor module with 3 pins and I have no data sheet. But what I have found from google is that pin 1 = power, 2 = ground, and 3 = output. I post an image below how I have connected it so far. The problem is that the sensor seems to give no sign of working when a magnet is nearby. By using analogRead and the seriell monitor i can see the sensors value is between 892-893 (depending on resistor). What am I not understanding? Thanks in advance.
KY-024 Hall effect sensor giving bad readings - Sensors - Arduino Forum
Hall sensor - do I get something wrong? - Science and Measurement - Arduino Forum
Getting the position from two between hall sensors? - Project Guidance - Arduino Forum
Reading 2 wire hall sensor - Sensors - Arduino Forum
Arduino Hall Effect Sensor Tutorial - Interfacing Hall Effect Sensor with Arduino
Explore - EasyEDA
How to Use a Hall Effect Sensor With Arduino, Arduino
Arduino KY-035 Hall magnetic sensor module - Error - Microcontrollers - Arduino Forum
Guidance on Hall Sensor Digital Output Issue - Project Guidance - Arduino Forum
Using the Hall effect sensor 44e 402