4.9 (601) · $ 10.99 · In stock
Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
Aerospace PCB Tips for Thermal Management
794 questions with answers in MESH
794 questions with answers in MESH
794 questions with answers in MESH
Top Simulation Software for 3D Printed Parts
SimScale - Another Fine Mesh
794 questions with answers in MESH
Inflation does not follow edge of airfoil
Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum
How accurate are SimScale's CFD results? Can I use it for academic research? - Quora
SimScale - Another Fine Mesh
Your Guide to Meshing Techniques for Efficient CFD Modeling